Q: What do I do if I push on the gas and it goes backwards

The car won't start or the car won't turn over? Car won't start would not be the battery, but some other cause like the fuel pump or the ignition module. The battery may be the cause of won't turn over...

If the motor does make a noise when the Down button is pressed, then the motor is not the cause; either the regulator is binding the motor from turning the window up, or the switch needs to be replaced at...

Hello. This suggests you have a faulty connection or a power shortage somewhere in your electrical system if there is no power coming to your car from the other car. If there is power, but just a clicking sound this...

Typically when the word jumped time is used, this means the timing belt (https://www.yourmechanic.com/services/timing-belt-replacement) is the issue. According to my information system, this motor is an interference motor. Which means when the belt breaks, it damages the pistons and valves....

The manual shift shaft transmission switch also known as the neutral safety switch on this transmission is located inside the transmission. The switch is only serviceable by removing the transmission oil pan and internal valve body for access to the...

Hi there. It sounds like there could be a rear wheel bearing causing the drone. Has anyone checked the rear wheel bearings? They may have gone overlooked due to the front wheel bearings; it does happen. I suggest having a...

Hi there. Check the spark plugs and make sure that they are creating enough spark to allow the fuel to burn. If there is great spark and the engine acts like it does not want to start, then there could...

The occurrence of code P0900 is probably not related to Service Campaign 15B22 (https://static.nhtsa.gov/odi/tsbs/2015/SB-10058725-1330.pdf?_ga=1.163152181.88204048.1469644261). That service campaign was initiated by Ford because TCM's were failing to set codes (illuminate the check engine light) when faults occur. Your situation is the...

Hi Bryan. Thanks for contacting us today. This might be due to a damaged electrical relay or perhaps the battery cables themselves were damaged during the cross-connection. It is also possible that the ECU may have been damaged or other...