Q: what cause why going out the ignition coil while running

I would have the car scanned with an ABS scan tool (https://www.yourmechanic.com/services/abs-light-is-on-inspection) to have the problem diagnosed.

Hi, this comes up often. Your car battery light being on is an indication that your engine is not getting enough energy. This could be because of a malfunctioning alternator or a battery going bad. I suggest having a certified...

Thanks for writing in about your Mazda 6. You need to make sure that the mass airflow sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement) is not getting contaminated by an oil type air filter. If it is, replace the air filter (https://www.yourmechanic.com/services/air-filter-replacement) with clean paper...

Good day: Unfortunately, we don't see a lot of Holden Zafira's here in the United States, so it's difficult to give you an accurate diagnosis of what might be rattling under the bonnet of your car. If you just had...

Hi there. Volkswagen's history of dependability on their larger four-cylinder diesel engines is rather impressive. In recent years, their reputation has taken a huge hit, however it was with their smaller, consumer car division. The Transporter is fairly smooth to...

Hello - the Downhill Assist Control (DAC) (https://www.yourmechanic.com/question/what-does-the-downhill-assist-control-system-do) uses engine compression (without ignition) to provide "braking" without heating up the brakes on a long descent. This makes a somewhat "unnatural" sound much like you describe from the exhaust. It is...

The lights can be purchased from many online sources, such as Amazon or eBay. You should be careful though. There are a few problems with replacing the lights with LED lights. LED lights require much less electricity to run and...

The ABS refers to the anti lock braking system. When the light is on it doesn't mean you don't have any brakes, It means that the automatic system that keeps the brakes from locking up when you are on a...

Check the transmission fluid level and condition as a very low fluid level, or a clogged fluid filter, will result in no movement. Check to be sure the shift cable is actually moving the manual lever on the transmission case...