Q: We need two transmission solenoids replaced

This engine had quite a few different issues that may of caused a no start. The list is ignition module, distributor stator, fuel pump, fuel pump relay, timing belt, ignition coil and wiring issues. The only way to fide the...

The fuel pump on your vehicle mounts underneath your back seat. From the fuel pump to the engine, the lines run along the underside of your car. The fuel pump and lines need to be inspected visually to verify where...

Yes this is actually bad. Get a thermostat. For most cars, they don't cost much, unless you own one of those V12 Jaguars, that you've got to take the intake manifold off to change it or a VR8 Volkswagen where...

Yes it is true. I'd go for the Camry (https://www.yourmechanic.com/scheduled-maintenance/toyota-camry/) by far. Those 6-speed autos are tried-and-trusted transmissions. They can last a really long time. For Hondas (https://www.yourmechanic.com/scheduled-maintenance/honda-accord/), it has always had problems with the automatic transmissions and the CVTs...

Hello. This is very normal for nearly every car. When your car's engine is cold and has been sitting for a while, the oil that is brought to the top of the motor when the engine is running will slowly...

I believe the "official" procedure for these M30 engines is to: Leave the tensioner until last Install the chain with the crank and cam sprockets on TDC, and the chain tight on the driver side of the chain Use the...

Hi there. The two OBD-II error codes you posted including the P0098 OBD-II Trouble Code (https://www.yourmechanic.com/article/p0098-obd-ii-trouble-code-intake-air-temperature-sensor-2-circuit-high-by-jay-safford) and the P0238 code (https://www.yourmechanic.com/article/p0238-obd-ii-trouble-code-turbocharger-boost-sensor-a-circuit-high-by-jay-safford) are similar in many ways. The P0098 code (https://www.yourmechanic.com/article/p0098-obd-ii-trouble-code-intake-air-temperature-sensor-2-circuit-high-by-jay-safford) indicates that there is an issue with the intake air...

Hi There, This may be related to a dirty or faulty mass air flow sensor or possibly a dirty or faulty idle air control valve. The idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) monitors the air intake as it is mixed with...

Hi there. It seems that the EGR (Exhaust Gas Recirculation) Valve is stuck and not allowing the engine to run good causing the engine to hesitate, especially when shifting. Take the EGR off and clean it. Then put it back...