Q: Truck won't start, just brought a new battery last week and had the alternator checked and it was good...won't start

If your seat belts get dirty, you can clean them very easily. However, you should never use a cleaning solvent or bleach on the seat belt. Instead, wash carefully with warm water and a mild soap.

The most common cause of a clutch pedal that will not retract is the clutch itself, or the slave cylinder. With the clutch not disengaging, this vehicle is not safe to be driven until the repairs have been completed. A...

The definition for the code P0068 (https://www.yourmechanic.com/article/p0068-obd-ii-trouble-code-air-assisted-injector-control-circuit-high-by-andrew-quinn) is throttle body airflow performance. A few more things will have to be checked as this code can come from a failing sensor that is offering the computer improper signals. Consider hiring one...

Hello, thanks for writing in. The driveshaft assembly is composed of the driveshaft, U-joints and snap rings. Both ends of the driveshaft connect to the output shaft and differential via yokes. If you would like help with this replacement, consider...

Hi - do you mean the code is P0101 (rather than P1010)? The P0101 code is mass air flow sensor. In any case, given the behavior of your engine and the Check Engine scenario you describe, yes, a dirty Mass...

Hello. Thanks for writing in. The universal oxygen sensors, a bad connection, or a bad catalytic converter can all be the cause of the codes (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection). If you can you access to a known good oxygen sensor and test it...

What you are describing sounds the cold start enrichment process may be enrichening the fuel supply a bit too much. When you start your vehicle in the morning and turn the key to on, the coolant temperature sensor immediately reads...

Hi there - no, gasket sealer should not be required. the thermostat should come with an o-ring, and the water pump should come with a paper-like gasket. Neither should require gasket sealant as long as the o-ring and gasket are...

Hello, thank you for writing in. If you are not doing any damage to the cap when you remove and replace it, the cap will likely be fine. However, any time you mess with any component over and over again,...