Q: Truck not getting any power

asked by on

The truck isn't getting any power at all. I cannot get it to start, or even turn over.

Hi. If the battery is fully charged and there is no power at the dash after the key is turned to the on position, I would suspect either a failed fuse or a faulty ignition switch. A car that new should be covered under warranty, but if you need further assistance, I recommend you have a mechanic, like one from YourMechanic, inspect the starting problem with your vehicle.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1,000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!
  1. Home
  2. Questions
  3. Truck not getting any power

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Master cylinder missing a wire

Hello. The brake light can come on for a number of reasons. If the brake pedal feels fine, then the problem is usually electrical. If the only light that is on is the brake light it is typically caused by...

Q: AC question - 2003 Chevrolet Tahoe

You may have a bad temperature blend door actuator for the left side vents. You should also have the complete system checked to make sure you are not low on refrigerant since the left side will be warmer than the...

Q: My check engine light came on after getting a jump start from AAA and when i got home i turned the car off and the light stays on

Hello. From what you describe it would appear that your vehicle is experiencing more than one issue. P2070 is the code indicating the intake manifold tuning valve is stuck open. This may be linked to your performance issue. Dark smoke...

Related articles

P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.