Q: Transmission fluid pressure sensor not working.

The EVAP system is used to prevent fuel vapors from escaping into the atmosphere. The powertrain control module (PCM) monitors this system to ensure it is completely sealed. If a leak is detected, the PCM will illuminate the check engine...

The autolock feature automatically locks your doors when your vehicle begins moving. This feature can be turned on or turned off by following these steps: 1. Press the Up/Down buttons on the steering wheel until Settings is displayed on the...

If you cut the cable that goes to the shift indicator, just see where he cut it. All the wires are color-coded so you can replace them together and get them back in. But the reason he cut them is--there's...

The most important thing to understand about electricity is it occurs on the atomic level. What appears to be a good connection to the human eye may not be to electricity. This is why we have test lights and multimeters...

Hello there, many faults will cause your 2006 Nissan Quest to not start or crank. You have done great in replacing the battery first, as this is the most likely fault in most cases. Other common is the starter, battery...

Hello - your Mercedes transmission is in "limp mode (https://www.yourmechanic.com/question/car-stuck-in-limp-mode)". Something has failed in the transmission, and it has engaged 2nd gear as a limited means of getting you to a repair shop. If you could forward the specific codes...

The problem you are describing is electrical in nature. When this new type of "electronic" steering system first saw widespread use, there were occasionally problems due to design glitches and unforeseen operating issues. In 2009, there was a Lexus Service...