Q: The battery light comes on and the brake light comes on the dashboard lights go off the car starts to drive weird the gas hand goe

Hi. If the engine cranks normally but doesn't start, most likely the engine is not getting fuel or spark. Just because you have fuel pressure from the pump doesn't mean that fuel is getting to the engine. In modern vehicle,...

It is in the lower hose. It is mounted in a plastic housing with two bolts where the lower hose meets the engine. If you are considering replacement, I would replace the housing too. They tend to warp and leak....

Hi, thanks for writing in. It appears that there may be an issue within the column. The controls for the wipers and turn signals are separate units, but are connected by a series of wiring within the column, and there...

It is very possible that you could have an issue with your steering or suspension parts (https://www.yourmechanic.com/services/brakes-steering-and-suspension-system-inspection). You may have a ball joint (https://www.yourmechanic.com/services/ball-joint-front-replacement), tie rod (https://www.yourmechanic.com/services/tie-rod-end-replacement), or wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement) that has some free play. I would recommend having...

Hi, thanks for writing in. Your battery may not have had enough cold cranking amps (CCA). The volts may be correct but if it doesn't have enough CCA, it will not start for you. Batteries that specify cold cranking amps...

This is likely a sign of a failing EVAP purge solenoid. The EVAP system prevents fuel vapors from the fuel tank from escaping into the atmosphere. The EVAP system collects and temporarily stores the fuel vapors in the charcoal canister....

Hello. The key code here is likely the P1775 code, which means the solenoid for invoking torque converter clutch lockup is latched (or engaged). If this solenoid does not unlatch, or release the lockup clutch, the transmission controller gets "speed...

Hello. It sounds like you have a battery issue. If the jump starting got the vehicle going then that means that the battery alone could not produce enough power to start the vehicle. If the battery is low enough it...

Hi there. The EVAP detection pump on most Chrysler's are located under the driver-side rear wheel well. To access and properly remove it, I would highly suggest purchasing a service and repair manual for your vehicle.