Q: tengo una falla con un jeep 2008 no tengo pulsos en la bobina del cilindro 1 y 4 ya cambie la bobina ,ya me revisaron la computadr

Hello, A coolant leak needs to be repaired sooner than later, as overheating can lead to engine damage. You will probably need the aid of a mechanic, such as one from YourMechanic, who can pressurize the system with a hand...

The AC system needs to have a performance check run. The AC compressor needs to be checked for operation and a set of AC gauges put on the system to help diagnose the issue. If the system is low dye,...

You should first lift wheel off the ground and support it. Then try wiggling the tire up and down or side to side to see if you feel any looseness in the wheel bearing and hub. Then spin the wheel...

Hello there, many faults will cause your RPMs to increase but the car not to accelerate. This is called a slipping clutch and happens when power is applied when in gear. There are several causes for a slipping clutch; the...

It sounds like you may have a faulty thermostat as well as a bad coolant temperature sensor. If the coolant is not getting to the heater core, then this would indicate a bad thermostat or a clogged heater core not...

Hi there - your symptoms suggest a leaky exhaust pipe or muffler (https://www.yourmechanic.com/question/exhaust-manifold-makes-noise), possibly just a leaky gasket or coupling. The rattling noise could be a loose heat shield which resonates at certain engine speeds - a fairly common problem....

Check over the vehicle for all safety items on the chassis and cabin compartment. Make sure that the vehicle is safe to drive in any condition. I recommend that if you have to replace any suspension or steering components or...

Hello, thank you for writing in. The moment you put your key in the ignition, or get into the vehicle with a keyless starting system, the vehicle begins to run tests on its monitored components. The oil pressure system is...

Hi there. Essentially, the P0365 code means (https://www.yourmechanic.com/article/p0365-obd-ii-trouble-code-camshaft-position-sensor-b-circuit-bank-1-by-valerie-johnston) that there has been a lack of voltage detected from the camshaft position sensor B in bank 1 by the PCM within a few seconds of the engine starting. The camshaft position...