Q: Starter relay location?

asked by on

Hi, I need the starter relay location for a 04 Altima 2.5l. I'm no longer getting the ignition open "beep" either. Thanks.

My car has 90000 miles.
My car has an automatic transmission.

Hi, thanks for your question. This vehicle has an intelligent power distribution control module located behind right front headlight in engine compartment. This module is computer controlled and may require additional diagnostic testing. Hope this helps and best of luck!

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1,000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Starter relay location?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Put a new starter and battery and still won't start

With a fully charged battery in good condition, and the immobilizer (security) system off - check to be sure the immobilizer is not activated - if the starter motor does not operate at that point, there are only two possibilities:...

Q: Can i do a 370z engine/manual tranmission swap to a nissan altima s 2008 sedan

The 370z engine is a 3.7L V6 (Type VQ37VHR). It uses a completely different engine computer and consequently, you would have to carry over the entire electrical system from the 370z to the Altima. The suspension and alignment of the...

Q: Changing gears - 2009 Nissan Altima

Hello. There are a few common causes of this on your vehicle. Most of the time it is caused by an issue with the transmission fluid being old or contaminated or it may be a problem with one of the...

Related articles

P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...