Q: Stalls when coming to a stop, will start up again,run fine until next stop, rpm drop 600 to 0

asked by on

stalls when coming to a stop, will start up again,run fine until next stop, rpm drop 600 to 0

My car has 126000 miles.
My car has an automatic transmission.

Hi There, It sounds like you may have a dirty or failing idle air control valve causing your engine idle to fluctuate and eventually stall. The idle air control valve is a small valve on the engine’s intake system that reads the air intake as it comes into the motor. This is controlled by the car’s ECM which uses this information to make adjustments to the air/fuel ratio depending on various inputs such as outside air temperature, intake air temperature, load and various other things. As you accelerate, your car’s engine is receiving a much higher dose of fuel than when at idle and conversely, when you let off the gas pedal, there is a sudden change in this fuel supply as a result of your foot letting off the pedal. When this happens, the job of the idle air control valve is to bring this deceleration down to a slow and smooth idle rather than suddenly cutting off the fuel supply causing the motor to die. When the idle air control valve is not working properly, this cause a disruption in this process resulting in the engine not being able to idle properly. I would recommend having a professional come to your location to diagnose and inspect your vehicle.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1,000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!
  1. Home
  2. Questions
  3. Stalls when coming to a stop, will start up again,run fine until next stop, rpm drop 600 to 0

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: What engines will fit into my 94 s10 blazer its a 4 door 2wd

If your VIN has a "W" or "Z" in it the 4.3L engine used in model year 1993 and 1994 will fit and function properly with your existing engine controls. You have to match the VIN to the engine, though,...

Q: 2002 Jeep Wrangler engine cranks and takes a while to start, a few times refused to start, replaced spark plugs coils wires etc

I would recommend having the fuel pressure tester to determine if the fuel system is contributing to the issues you are experiencing. It is possible that the fuel pump could be getting weak not allowing enough fuel flow to the...

Q: Q: Car won't start or crank

Hi there. What voltage reading are you getting at the battery, terminals, wire, and starter; a voltage drop test will confirm if there is any resistance. What were the battery test results? Current voltage, cold cranking amps, state of health?...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
How Long Does a Heater Control Valve Last?
Keeping the right amount of coolant in a car is essential in keeping the engine at the right temperature. Failing to have the right amount of coolant or even bad elements...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...