Q: Speedometer not working

Older systems use a movable vane in the intake stream called a Vane Air Flow (VAF) sensor. The VAF sensor used in Bosch L-Jetronic, Ford, and most Japanese electronic port fuel-injection systems is a movable vane connected to a laser-calibrated...

There are many control switches to adjust the powered windows on your vehicle. On the driver’s side door, you’ll find switches to control all windows on your vehicle. If you need to adjust windows while in a passenger’s seat, you’ll...

The power steering pump, or high pressure hose may be leaking. If the temperature is cold outside, the fluid may thicken and cause a failure of the hose, or pump, or both. If this is the case, the fluid should...

The code U1262 point out a communication fault between the vehicle modules and a scanner. It may be best to visit your local dealer to find if one of the vehicles control modules has failed. In some cases this can...

The solenoid may be removed without removing the valve body, however, the valve body will need to be removed in order to get the harness out safely without damaging it. There are two bolts that hold the solenoid in as...

Hi, thanks for writing in. Depending on the severity of the surface area of the tire that has been patched and the location of the patch, this could be fine, but is not recommended. Sidewall patches are particularly vulnerable to...

Whenever the ECM is disconnected the idle control settings the ECM has stored in memory will be cleared. The ECM will revert to the factory-new settings and since the engine now has high mileage and the need for adjustments to...

Hi There, The best time to check the engine oil is usually just before starting the motor or after it has been shut down for 10-20 minutes. This allows for all of the oil in the motor to be drained...

Hello. In order to properly adjust idle speed on this vehicle you will need a scan tool. The vehicle will need to be put in relearn mode to do so. Over time the computer will adapt on its own if...