Q: Some times it won't crank over

The redial feature allows you to call the number that you most recently called with one easy command. To use the redial feature, simply press the Voice Recognition button, and then say “Redial."

Hello. There could be a few issues causing a crank no start condition. You could have a sensor that is failing when it gets hot like the crank or camshaft sensor. A failing ECT sensor can also cause a crank...

The problem is most likely a breakage in the transmission's internal output or input clutch. Another possibility is that a shaft broke when you started to move or the differential final drive gear broke. Before the transmission is taken out...

If your vehicle has a valet switch, it should be located on the interior of the vehicle. This switch is often times hidden in the glove compartment somewhere. Whichever button you pressed to activate the valet feature is the same...

I agree with the other mechanic. If the fluid looks dirty then this means the transmission was not serviced for a long time and if you service it then the new fluid will wash out all the clutch material (https://www.yourmechanic.com/article/how-does-a-transmission-filter-work)...

Hello there. The most common causes of a tire vibration (https://www.yourmechanic.com/article/what-causes-a-car-to-shake) are the inflation levels, tire balance, damaged wheel or tire or an alignment issue. With your car only having 1 mile on it, I would suspect that the tire...

The most common problem on this vehicle is the fuel pump (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuel-pump) and fuel pump module. If you remove the rear seat that the fuel pump cover is, on the passenger side. Listen to the fuel pump when it is...

This light will usually come on when one of two things are happening. Either the motor is in fact low on oil or the oil pressure sending unit (https://www.yourmechanic.com/services/oil-pressure-sensor-replacement) is not working properly and may be producing a faulty reading....

Hi there. The issue could be with the output shaft speed sensor on the tail shaft of the transfer case. The output shaft speed sensor is a sensor the registers the speed of the output shaft and lets the computer...