Q: Smoke from coolant filler

Looking at the wiring diagram for your vehicle, I see that all the brake lights share a common ground. They also all utilize the brake lamp switch, so both of these items can be ruled out. The only thing the...

The power steering pump (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-power-steering-pump) may be going bad if you are hearing a grinding noise. The fluid should not be red, unless the fluid was flushed out and replaced with transmission fluid. Power steering fluid is light brown like...

Hello there, a few different faults could be causing your 2000 Plymouth Breeze to stall. The most common would be the fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement), MAP sensor (https://www.yourmechanic.com/services/manifold-absolute-pressure-sensor-map-sensor-replacement), fuel filter (https://www.yourmechanic.com/services/fuel-filter-replacement), battery (https://www.yourmechanic.com/services/battery-replacement), alternator (https://www.yourmechanic.com/services/alternator-replacement), battery cable (https://www.yourmechanic.com/services/battery-cable-replacement), or a wiring...

If the previous owner specifically asked you not to, they may have known about an issues the vehicle has when using E85. It may be necessary to visit your local dealer to take a look at the truck to see...

Hello and thank you for your question. It sounds like the input turbine speed sensor B has failed or lost connection to the engine control module (ECM). You will first need to check the wiring to the sensor and see...

Hi there: If you've found oil in the spark plug well is a sign of a fairly serious problem that should be inspected and repaired immediately. It is almost always due to a failing gasket or O-ring but can also...

Hello. If you replaced your transmission and the engine is not starting the first thing I would do is to try to make sure the engine is rotating. You can do this by putting a breaker bar onto the crankshaft...

If the pedal is low, there is air in the brake lines or the master cylinder has an internal leak. If your vehicle is equipped with anti-lock braking, you have to either bleed the ABS pump and valving (per Factory...

Hi there. On a front wheel drive vehicle, the only two items that could possible cause this, besides a wheel bearing that was not properly lubricated and installed during the replacement, would be a brake caliper that is dragging on...