Q: Shifter sticking in park

Your touch screen system has a recall, R40 dated 7/28/2015, that pertains to the radio system being susceptible to a security vulnerability. The vulnerability could allow someone to access the system which could cause problems. The dealer will reprogram your...

Yes it does, but it should never rattle of course. The problem with yours is that the timing chain probably needs to be replaced because it has too much slack there or in the tensioner. Changing the timing chain is...

It may be your TPS like your father said, but tests would need to be done to diagnose it. If you have codes in the computer it would help with the diagnosis. The TPS is not a common problem with...

If you mean that you want a regular style key in addition to your key fob key, the key itself may have to be purchased from the dealership. However, any hardware store, Wal-Mart, and some auto parts stores will be...

Hi there. The P0420 code (https://www.yourmechanic.com/article/p0420-obd-ii-trouble-code-catalyst-system-efficiency-below-threshold-bank-1-by-jamahl-walker) you are getting can cause your car to run like this. The code typically means that the catalytic converter is failing (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-catalytic-converter) or one of the oxygen sensors may be failing (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-oxygen-sensor). If it...

There is an important distinction to be made here. Is your car not cranking or is it cranking but not starting? Most likely you have a bad connection and a jump start is adding additional voltage to overcome it. Either...

Hello - this issue suggests that either the engine/transmission wiring harness was damaged (https://www.yourmechanic.com/article/how-are-car-wires-protected-from-damage) when the bulkhead sleeve was replaced, or one of the engine/transmission CAN bus connectors is loose. The CAN bus is the major lelectrical signal connector between...

Any time when lights are flickering, there is a loose ground wire or a short. If the headlights are turned on and the interior lights are flickering, then either the ground wire in the steering column is loose or there...

HI there - possibly. If it is one of the pre-catalytic converter oxygen sensors (https://www.yourmechanic.com/article/how-to-buy-a-good-quality-oxygen-sensor), yes, it is possible to damage the catalytic converters. From the problem codes, this would be a "Bank 1/2, Sensor 1" - the operative information...