Q: Second and third cylinders misfiring

Hello. It is rare that a clutch is ever replaced on today's vehicles. On your Honda, the clutch it not a replaceable part. You should always replace the compressor (https://www.yourmechanic.com/services/ac-compressor-replacement) as a unit to prevent further issues. Keep in mins...

Hello! It sounds as if you have a restriction in your fuel supply or bad fuel pump. I suggest checking the pressure of the fuel system. A bad fuel pump or clogged fuel filter will cause the symptoms you described....

Hi there. Governors in a fuel system are basically a three-way valve. There is a supply port, exit port, and a dump port. As the fuel pressure regulator (https://www.yourmechanic.com/services/fuel-pressure-regulator-replacement) is set the fuel pressure will remain the same as when...

Hello, thank you for writing in. The first thing you will likely want to look into is the fuel on the spark plugs. It sounds like one of your fuel injectors may have failed. If they are leaking and too...

To determine if an engine is seized, one would turn it clockwise by hand using a wrench and socket applied to the crankshaft pulley bolt. That test is made easier if you remove the spark plugs so that there is...

The noise is the parking brakes are out of adjustment and the brakes are dragging. Check the rear brakes and see if they are releasing when going in reverse. If you need further assistance with your brake system (https://www.yourmechanic.com/services/parking-emergency-brake-does-not-work-inspection), then...

You will need to have the throttle relearn procedure performed using a factory level scanner or the codes will return. This is needed anytime the throttle has been changed.

Hi Jacob. Diagnosing an issue like this is best when you understand all of the possible sources of an OBD-II trouble code. When the signal to and from the camshaft position sensor and the PCM is broken, the ignition spark...

This may be a sign of a faulty MAP sensor as the vehicle responds adversely to a load put on the motor (i.e. putting it in gear, making turns (which makes use of the power steering pressure switch) turning on...