Q: Removal of driver's seat positioning switch plastic cover.
How do I remove the driver's seat positioning switch plastic COVER just below the seat itself? I have the rear phillips screw out and the front of the plastic strip unhooked. The rest is still attached a few inches or more from the front edge of the driver's seat. I need to remount the switch since it became loose. This is a 2002 Nissan Pathfinder, SE.
My car has 118700 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Engine making high-pitched noise
Hi, this typically points to an issue with one of your serpentine belts. These belts drive different components on the vehicle such as the water pump, alternator, and A/C compressor. Over time, they will begin to lose their grip which...
Replaced starter and flywheel twice and still have the same problem
Hi there, thanks for writing in about your 1993 Jeep Wrangler. Your vehicle starter was replaced by a new starter part number and the shim should not be used. If you are using an aftermarket starter, then you may need...
Check engine light
Hi there, thanks for your question. I'd be happy to help. A [misfire can be caused by a variety of things other than bad spark plugs such as bad plug wires, vacuum leak, dirty fuel injectors, a weak fuel pump...
Shaking, not knocking
If the car is shaking even while in park this suggests that it is related to the engine running poorly and not anything related to the drive train. Depending on the severity of the shaking this may be related to...
I replace the hood of my 2009 Chevy Impala with the hood of a 2007 Chevy Impala
Yes. The reference I checked, says that 2006-2013 will work.
My 95 Ranger shakes when accelerating from a complete stop.
Hey there. The different responses based on whether you are attempting to move forward or backward, suggests it might be a broken transmission or motor - allowing both to move around when the engine generates power for forward motion. Reverse...
Rear Brake light and turn signal not working on driver side
Lighting problems like this can seem very confusing, so it is best to start with the basics. Check for power and ground at the turn and brake light sockets. I suspect in your case you will have a good ground...
My car has a cable transmission and it will go in gear when the car is off but once running it will not go in gear
Hi there. Knowing more about your car, such as the year, make and model is needed in order to provide you with some accurate ideas. In general however, this issue is commonly caused to a slave or master cylinder within...
Ignition fuse keeps blowing, all back lights don't work, gauges messed up, can't shift out of park when engine is on.
The ignition switch is damaged and needs replaced. The contacts inside the ignition switch is are shorting out with itself. This is why the switch has to be in a specific position to release the shift interlock solenoid. If you...
Related articles
Nissan Certified Pre-Owned (CPO) Car Program
If If you have been shopping for a used Nissan vehicle, you may want to check out cars under their certified pre-owned program. Many manufacturers have a certified pre-owned (CPO) program, and each one is set up differently. Read on...
How to Replace a Backup Light Switch
The backup light switch connects to your transmission and turns on when you shift into reverse. This switch lets drivers know that you are backing up.
How to Become an Uber Driver
Uber is a ridesharing service that operates in 500 cities. To apply to be an Uber driver, download the Uber app and have your car inspected.
Browse other content
Estimates
Maintenance