Q: Power window not working

Installing a non-LATCH equipped car seat in your car is very easy. Here’s what you’ll need to do: Place the child seat in the car in the position where you want the child to ride. Route the seat belt through...

The model of vehicle is missing on this one. The most likely cause is the pump shaft seal or the reservoir to tank seal. Otherwise, the lines could be leaking. I recommend having a qualified mechanic inspect your vehicle, locate...

Hello. Brake squeaking may not necessarily indicate that you may need new brakes, sometimes it is just an indicator that they may need to be lubricated or cleaned. If you can see into your wheel, I would try looking into...

Generally, when the car is running consistently and on all cylinders, when stalling (https://www.yourmechanic.com/services/car-is-stalling-inspection) it is often times a fuel supply issue (or in some cases indirectly related to electrical - i.e. bad connection or pulse to the fuel injectors)....

Hello. If this occurred right after the vehicle was jumped and after driving the vehicle for a while then the fuses needs to be checked first. This is where I typically start as a battery (https://www.yourmechanic.com/services/battery-replacement) failure or a jump...

Hello. The symptoms you are describing can be caused by a few different things. If the same lights as before are no longer working then it may be possible that there is an issue with the instrument cluster that is...

Hi there. Check the camshaft (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) and crankshaft (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) position sensors and make sure that they are plugged in. If the engine is cranking but not starting then the crankshaft position sensor could have failed. Also, check the mass air...

On many early 2000's Ford cars and SUV's, a shift control failure can trigger limp mode; however, this usually triggers an OBD-II code and illuminate the check engine light. Try downloading all codes to see if this is the issue....

A possibility is the motor/transaxle mounts are worn or sagging and that causes misalignment of the CV axles accounting for the noise and vibration. However, that is just one possible scenario. Vibration under acceleration could also be due to an...