Q: Overheating only sometimes when idling new radiator water pump thermostat and cooling sensor

The clutch slave cylinder (https://www.yourmechanic.com/parts/clutch-slave-cylinder) is part of the hydraulic clutch system that includes the hydraulic slave cylinder, master cylinder and metal, and plastic or rubber lines from the master cylinder to the slave cylinder. The slave cylinder may be...

Your map lights provide additional illumination for the driver and front passenger. They turn on when your interior lights are set to on or the door setting, but they can also be operated independently. To use your map light, just...

The speedometer on your Mustang is electronically controlled. The speedometer is powered on the light green with yellow stripe wire from the #8 fuse in the dash panel fuse box. The grey/black and the green/orange wires go to the vehicle...

Hey there, thanks for writing in about your 1994 Honda Prelude. Go back to the shift linkages and check the integrity of the connections. Any looseness here will result in misalignment problems changing gears. Have this shifting problem inspected (https://www.yourmechanic.com/services/car-is-hard-to-shift-inspection)...

Hey there, thanks for writing in about your 2001 Toyota Celica. There are a few things that may cause this situation. If the transmission starts to slip, there may be a problem in the hydraulic part of the system like...

Hi there. I understand how frustrating things like this can be. Base on what you've described, the year, and mileage of the vehicle it sounds like your battery has gone weak or failed internally. A good battery test with a...

Hi there. Since the warning light is coming on, I would usually scan the computer for codes (https://www.yourmechanic.com/article/how-to-read-and-understand-check-engine-light-codes-by-jason-unrau) to see what is going on. Most of the time this is caused by a failure in one of the transmission sensors...

Hello. In order to remove the oxygen sensors, you will likely need an offset oxygen sensor wrench. An offset oxygen sensor wrench will be compact enough to fit into low clearances but still provide enough torque to break the sensors...

I have to wonder if what you are actually looking at is a relief cut in the flywheel that is in the outer perimeter near the ring gear. It's hard for me to imagine that you could really do...