Q: No air coming out of vents

Depending on the trim level of your Accord, you will have one of two types of spotlights. Both work similarly, though. Here’s what you need to know: Press up on the outer edge of the spotlight. You’ll hear a click,...

Hello, it sounds like you are really close to a solution since you know what is causing the draw. I would check with the relay that powers up the PCM. Locate the PCM relay in your owner's manual or fuse...

The remote keyless entry transmitter battery usually lasts for a few years. If the battery dies, you can easily replace it by following these steps: 1. Use a narrow tool to pry open the center cover of the transmitter. 2....

There are many questions that should be answered before diagnosing this type of question. Does the key not turn the ignition, or does the ignition turn but the engine will not crank, or does the engine crank but with no...

There is a service bulletin to replace the two battery cable ends on these vehicles. It seems like the cable ends do not tighten and make good contact. You would have enough power to lock and unlock doors, and you...

Some of the things that a technician might suspect and decide to test on your Kia would be the cam timing (timing belt might have jumped), crankshaft position sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor) function, engine compression, and fuel pressure. Using a scan tool...

Windows motors are designed to move in both directions and if you operate the motor in both directions and hear the noise inside the door like a grinding noise, then you have a bad window regulator (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-window-motor-regulator-assembly). It is possible...

Hello, the automatic transmission has 3 systems; electronic, hydraulic, and mechanical. What you described could be an internal mechanical failure with transmission. The electrical system which includes the module, will go into a default mode if there is a failure...

If your heater only blows when the setting is on high, this may suggest that you have a faulty blower motor resistor (https://www.yourmechanic.com/services/heater-blower-motor-resistor-replacement). The highest speed setting may still work because in most cars in the highest fan speed settings...