Q: New battery, radio will come on but it will not crank

Some signs that a tune up is needed include, rough engine idle, hesitation during acceleration, and poor fuel economy. A tune up on your particular vehicle would include spark plugs and an induction service. The induction service would remove the carbon...

Hi there - the P2015/P2020 (https://www.yourmechanic.com/article/p2015-obd-ii-trouble-code-intake-manifold-runner-position-sensor-switch-circuit-range-performance-bank-1-by-spencer-clayton) codes indicate a problem with the intake runner position sensor. This component keeps track of the intake runner flap position, as opposed to regulating whether it is open or closed. I recommend a Check...

Motor and transaxle mounts, or an engine operating condition such as misfiring, are likely causes. A fault in the transmission is a less likely cause of the shaking that you are describing. Motor mounts fail due to separation or tearing...

Hi there. In many cases when a crankshaft position sensor issue is found, the actual culprit is the wiring harness that has been damaged and needs to also be replaced. If this was not completed when you replaced the sensor,...

If you call out a mechanic to install a part that was diagnosed by another company then to answer your question is no. The mechanic that is to install a previously diagnosed parts cannot in most cases verify the part...

It sounds like it may have originally been over filled. Fill 4-5 quarts, then start the truck and then slowly fill up the remaining fluid. This should keep it from leaking from the vent hole.

This is a problem in the garage a lot. You connect a battery and the alarm sets, then the car goes into lockdown and you can't start it. Sometimes it takes some experimenting. I would start by charging the battery...