Q: Need help need myvcar fixed and no one im my area will do it

The purpose of an air filter (https://www.yourmechanic.com/article/what-s-the-point-of-the-air-filter-in-my-car) is to filter out dirt and contaminants from the air before it gets inside the engine, where the air mixes with fuel and gets burned. As a normal consequence of its operation, the...

Simply disconnecting the battery should not have any adverse effects on the vehicle. The exception to this is if the battery was hooked up backwards, this could cause strange electrical faults. The most likely cause would be a wiring issue,...

Hi. It should be a fairly simple cause. I suggest checking your tires for uneven wear because that is the number one cause of pulling next to an alignment being out up specifications. So have the alignment checked (https://www.yourmechanic.com/article/how-to-know-if-you-need-a-wheel-alignment-by-robert-tomashek) as...

Hi there, thanks for your question. These procedures are vehicle specific as they are not all assembled the exact same way. Basically, you want to disconnect the battery before doing anything else. To do this, loosen the belt tension and...

Hello. A stalling issue (https://www.yourmechanic.com/services/car-is-stalling-inspection) like this may take some time to figure out. If you suspect your fuel tank is dirty, you may want to drop it and inspect it. However, these symptoms are more likely to be related...

The heater core fins are blocked with dirt, hair, debris from inside and outside air and will not let enough transfer of heat to the air. Core may need to be replaced. The temperature control actuator may not be moving...

The thermostat housing if it is leaking and cannot be sealed will need to be replaced. The plastic may be deformed and cannot seal completely.

Be sure any engine immobilizer system (security system) is not activated, thus preventing the car from starting. The battery should be load tested by a professional. Load testing can only be reliably performed on a fully charged battery. If the...

Hello, thank you for writing in. Often the Steering Angle Sensor can be re-calibrated when it has lost connection. A manufacture qualified technician can perform this programming for you, unless you have access to a quality OBD-II scan tool. If...