Q: Need help dropping polyethylene gas tank.

asked by on January 04, 2016

I was in the process of dropping the polyethylene gas tank. Their are two push connectors at the top of the tank that I cannot figure out how to disconnect.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do I turn autounlock on or off?
The autounlock feature automatically unlocks your doors when the shifter is put in the P position, and the ignition is turned off. This feature can be turned on or off with just a few steps: 1. Press the Up/Down buttons...
when driving speed slow down and resume to speed it begins to jerk i have to put in over drive to resume speed especially on hiway
You should have the vehicle scanned. The data from the speed sensor needs to be checked to see if the transmission or engine is the cause of the jerking. You may have a transmission solenoid that's not shifting correctly, an...
I have a loud squealing noise that is intermittent.
Hi, thanks for writing in. Usually, squealing noises are attributed to a loose belt somewhere on the vehicle, in which case, the serpentine belt could be the issue. However, since you're experiencing this only during the reverse gear, it could...
There is a sound noticed when fully turned position in both right and left and forward and backward direction. Grinding sound.
Good question and you are correct. It sounds like it is your power steering pump. There is only one noise a bad power steering pump makes, and no other part will make the same grinding noise as the power steering...
Engine turns but won't start - 2001 Mercedes-Benz ML430
Hello and thank you for your question. Check for the three essentials that the engine needs to run. Check for air in the engine and make sure that the air filter (https://www.yourmechanic.com/services/air-filter-replacement) is not plugged up. Check for spark to...
Oil pressure sensor or oil pump
If you have low oil pressure indication and getting engine noise then the oil pump is most likely the cause and not the oil sending unit. In order to verify the cause the oil pressure would need to be checked...
My RPM is very erratic and the engine surges on my 2006 Hyundai Elantra
Hello. I would usually start by scanning the computer for codes to see if anything comes up. If there are no codes then I would check and see if there are any sensors that are not reading correctly. It sounds...
Pressure plate is grinding after clutch installation?
Hello. It sounds to me like something is misaligned, too wide or out of adjustment. The old and new parts should have been compared before you put the new parts into your vehicle to make sure everything lines up. I...
How do I fix this? 2002 Hyundai xg350 Transmission Control Relay Always On: I replaced the TCM, no fuses are blown. Still broken.
The only way to fix this issue is to go through the test protocol (diagnostic decision tree) in the Hyundai factory service manual. In particular, for this code (P1723) the circuit to and from the module has to be tested...

Related articles

How Long Does a Fuel Tank Last?
The The fuel tank is responsible for holding the gas or diesel that runs the vehicle. Obviously, this job is very important. On top of being extremely inconvenient, a leaking or faulty fuel tank is downright hazardous. Gas vapor is...
A Buyer’s Guide to the 2011 Dodge Dakota
2011 2011 marked the final year of production for Dodge’s venerable Dakota pickup truck. It was a compact pickup, not quite the size of the Ram, and competed with similar models like the Chevy S10 and the Ford Ranger (both...
The Best Used Cars to Buy If You're Towing a Boat
If If you’re towing a boat, the vehicle that you buy is largely going to depend on the size and weight of your boat plus trailer. Most cars, realistically, aren’t cut out for the job. We recommend a pickup truck...