Q: My truck is getting no spark

Hello. I would typically start by checking all of the sensors inputs with a scan tool to see if any are not reading correctly while starting. Most of the time, it is the air flow sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-mass-airflow-sensor) or the crank...

I am not aware of any problems about removing and replacing a driveshaft when the vehicle is warm. I however have seen transaxle damaged from not installing the axle all the way into the transmission and engaging the axle fully...

A few different things can cause the vehicle to respond this way. The reason why the key is stuck in the ignition is probably due to the steering wheel being locked. When the steering wheel is locked it does not...

Hi there: First off, we glad you're safe and that your car didn't shut off while driving through the deep puddle (https://www.yourmechanic.com/question/car-stalled-in-high-water). One of the hardest things to diagnose is electrical issues (https://www.yourmechanic.com/services/electric-problems-inspection) that are caused by water damage. Sometimes...

Hi there, thanks for writing in about your 2012 Kia Rio. If you only hear clicking, then you should have the starter checked to see if it is getting power. Replace the starter if there is power when you try...

Hi there. The problem with most shaking and vibration issues is that one damaged component like broken motor mounts can mask other parts that may be damaged. A cracked exhaust manifold (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-exhaust-manifold) is one of those that can cause the...

The suspension could be loose or have a broken bushing causing the control arms to move around or the shock absorbers are worn and causing the tires to bounce violently at highway speeds. If you need further assistance with your...

Check the ground wires on the back of the vehicle as they are either broke or loose. Over time the bolt that holds the ground wire to the frame tends to become rusty causing the ground to have a high...

Be sure the wiring harness is connected to the transmission, although in drive the manual valve (in the transmission valve body) should at least get you into 1st gear. Check the fluid level. If fluid is really low, the transmission...