Q: My starter was spinning so I had a new starter replaced. drove the car for a day and it started ever time but not on Sunday afternoon as it spins fast.
asked by
Dan O
on
March 06, 2017
new starter still spins from time to then starts great
My car has 86100 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
The problem may not be the hub or studs, but the rim (https://www.yourmechanic.com/article/how-rims-work-and-why-they-matter). Look at the inside of the rim-centering hub to see if it has damage where it has not been seated properly or is unable to be seated....
Hi. There could be a couple reason why your car is not starting. One there could be a problem with the camshaft sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) or crankshaft sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) being faulty causing the car not to have spark which will cause...
Hey there. The battery and starter are key components to starting the vehicle. If the battery is weak (https://www.yourmechanic.com/services/battery-replacement), it can cause a slow or sluggish cranking if it is not providing enough power to the starter. Also, the starter...
Hello. Yes, you are correct - the P0325 (https://www.yourmechanic.com/article/p0325-obd-ii-trouble-code-knock-sensor-malfunction-sensor-1-bank-1-by-spencer-clayton) is indicative of a failed knock sensor (or the knock sensor wiring). I think it is a rare circumstance where you would not want to make this repair. It is straightforward...
Hi there. What could be the issue is the main valve to the transmission may have disconnected from the shifter lever on the side of the transmission. Raise up the vehicle and put it on four (4) jack stands. With...
You will need to have the car checked for the reason the check engine light is coming on? The vehicle is going into failsafe mode and not shifting transmission. Once you get the codes from the computer you can then...
The factory brake pads do have a noisemaker tab that scrapes the brake rotor when the brake pads reach replacement thickness. It's pretty loud, so if you just have a mild squeaking that might be something else. At 80 K...
If you have only cleaned the Mass air sensor and have replaced all the O2 sensors then the only other possible cause for the P2a00 is the mass air sensor. I recommend replacing the mass air sensor and relearning the...