Q: my starter is not working what should i do to atsrt my ford 500 2007 model

Greetings and thank you for writing in about this problem! This is a well-known concern for this generation of Tacoma. Toyota is well aware of the issue and has provided a recall for this concern (TSB LSC-90D). The original recall...

The first thing you'd want to do is change the thermostat. It is a cheap part, so change the thermostat first to see if this remedies the problem. They often just don't heat to the operating temperature because the thermostat...

If you have an issue with your clutch pedal going to the floor, the slave cylinder is normally the cause of this circumstance. Also, if the push rod has been broken the first step would be to track down a...

Hi and thanks for contacting YourMechanic. What you are experiencing is a misfire detected in cylinder 1 and a random misfire in cylinder 3. This could be caused by either the fuel injectors (https://www.yourmechanic.com/services/fuel-injector-replacement) not firing, the spark plugs (https://www.yourmechanic.com/services/spark-plugs-replacement)...

Hello. If you are referring to the front cv axles they can have a small amount of play in them. The inner joint can have a small amount of in and out movement as well as some up and down...

Hello, thanks for writing in. This depends on a wide variety of factors that would need to be evaluated individually along with the Jeep being physically inspected and diagnosed by a professional. If you'd like to have this done, I...

Hello, thank you for writing in. The vehicle will illuminate the reduced engine power warning light (https://www.yourmechanic.com/services/warning-light-is-on-inspection) for many reasons. The throttle, a number of sensors, poor ignition, and many other factors can turn it on. If you have not...

Hi there. With the problems that you have mentioned, this could be an expensive fix, depending on what is wrong with the clicking sound and what is wrong with the transmission. The clicking sound is more of a CV Shaft...

Hi Cassi. Thanks for sending us a message tonight. Yes, the P-0171 OBD-II trouble code (https://www.yourmechanic.com/article/p0171-obd-ii-trouble-code-system-too-lean-bank-1-by-andrew-quinn) indicates a lean mixture issue, which will impact the pass/fail of most emissions tests. Depending on where you live, any check engine light or...