Q: My Mom car will start but do not turn over so we can drive

Hello. Diagnosing a noise is a hands-on job and requires listening when the engine is running. Diagnosis may require a stethoscope to check around while the car is running or possibly removing the engine belt. You could have a noisy...

As long as you can safely shift the transmission without grinding the gears, and the clutch is shifting you should be fine. This sounds like an issue with the clutch hydraulic system (https://www.yourmechanic.com/article/how-a-hydraulic-clutch-system-works). You may be able to have a...

An engine that cranks but doesn't start is lacking one or more of the following: compression, fuel, or spark. Each of these will need to check systematically to narrow down the cause. Fuel pressure can be checked at the rail...

Hello and thank you for your question. It seems to be the transmission that is causing the engine to stall out when you are putting the vehicle into drive. The transmission could have a converter clutch lock up issue causing...

It really does sound like your battery (https://www.yourmechanic.com/services/battery-replacement) has gone dead. Sometimes they can develop an internal short where they seem fine one moment then go dead the next. The indicators on the chargers usually don't tell the whole story....

The rings you are pointing to in the video are actually the retaining rings. Unless they are broken, they really shouldn't need to be replaced. The ring on the male part of the splined shaft should pop into a groove...

Good afternoon Sybil. Thank you for continuing to ask questions. The more you know about the issues with your car, the better informed you will be to make good decisions about repairs The Manifold Tuning Valve for your Sebring can...

Hello. It is very hard to properly diagnose something without driving the vehicle and fully testing it. You will more than likely need to pay for a diagnosis to know for sure what is going on. From my experience though...

This is a common symptom of a failing crankshaft position sensor and as the code indicates, this means the sensor needs to be replaced. A crankshaft position sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) is an electronic device used to monitor the position or rotational...