Q: my ign fuze keeps burning out i put a new battery cable in and is still burning out the next day after i remove my ecu. im not sur
my ign fuze in my car keeps blowing out I have a new battery I just installed a new cable to the battery and new fuze and it starts then the next day its blown after I remove my ecu.
My car has a manual transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Car suffering a loss in power
If the issue seems to be in time with the crank pulley, then it may be a timing issue. This engine tends to have a history of misfire issues, typically from bad coils. I typically start by scanning the computer...
Power steering hard to turn
Although you added fluid, did you check to see that the level was in the appropriate mark for what the temperature the engine is (cold/hot)? If so, its likely that the pump bearing has failed and which means the unit...
Whining during acceleration with high RPMs, in lower gears and overdrive
I agree with the mechanic that checked it. It needs to have the transmission overhauled. I cannot make the decision if you should get it done or not, since it is a very expensive repair and may exceed the value...
Steering wheel jerking
Hello. If there is a consistent jerk occurring, then it is typically a spool valve problem in the rack and pinion. This would require replacement of the entire rack and pinion assembly. It can also be caused by a failing...
Bubbling in coolant overflow tank
Seems to me like you just answered your own question. The coolant bleeder is stuck. If you cannot get the coolant bleeder unstuck then you should see bubbles in the overflow bottle for up to a week to completely get...
Car stalls, have to start from neutral. 1997 Jaguar XJ6
This might be the idle air control valve failing (https://www.yourmechanic.com/services/idle-control-valve-replacement). Since this is one of the electronic engine controls which interacts with the engine management system to control idling specifically, it is a prime candidate for this mode of failure....
Hi Ben I noticed That when i took the inertia switch out my truck I heard something one is rattling is that normal
The inertia switch has a metal ball inside the switch that will make contact between the two terminals of the switch when working properly. The inertia switch is designed to move the ball away from the contacts in a roll...
Heater is running cold, engine light is on, rough idle
Hello there, many faults will cause your heat to blow cold and check engine light on with your 2007 Honda CRV. The first step in diagnosis would be to check what code your car has stored in the computer, this...
My fan for my a c and heater is only blowing air on 2 3 and 4 settings but not 1
The blower motor resistor, in the motor speed control circuit, is probably faulty. If your vehicle does not have automatic temperature control, the part that needs to be replaced is relatively inexpensive. If you desire a definitive diagnosis, and replacement...
Related articles
A Buyer’s Guide to the 2012 Honda CR-Z
In In the tradition of the sporty CRX, the CR-Z boasts some of the similar look, without quite the same amount of pep. That’s because the CR-Z is Honda’s eco-friendly offering and a pretty unique one to boot – (as...
The Best Used Cars to Buy if You Live Close to the Ocean
If If you live close to the ocean, your vehicle is going to be far more vulnerable to rust than if you lived further inland. And the fact is, when it comes to resisting rust, not all vehicles are created...
The Most and Least Expensive Cars to Insure
Car insurance quotes depend on the car make and model. The Honda Odyssey is the least expensive and the Dodge Viper is the most expensive to insure.
Browse other content
Services
Maintenance
Cities