Q: My gear selector malfunctioning

Hi there. A common solution for a radio that does not work is to have a mechanic check any fuses or connections that go to your stereo. As for your speakers not working, this may be due to a loss...

Hi, thanks for writing in. I'd be happy to provide my insight. There are a few other possibilities with this scenario. The blower switch (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-blower-motor-switch), the blower motor itself, function switch or the blower fan relay (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-blower-motor-relay) could have a...

Hello and thank you for your question. It seems to be the transmission that is causing the engine to stall out when you are putting the vehicle into drive. The transmission could have a converter clutch lock up issue causing...

This may be a sign of a failing idle air control valve. The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine. This valve is controlled by the...

Hi and thanks for contacting YourMechanic. All three codes refer to the pressure control solenoid in the transmission. Check the fluid level (https://www.yourmechanic.com/services/transmission-fluid-service) and top it off if the fluid is low. Check the harness to the transmission for any...

Hi there. From the description you have provided, there are multiple problems going on with your vehicle, so the faults may or may not be related. Although the car is showing many symptoms, this may not be terminal. It could...

Depending on what type of engine you have in your vehicle will determine if the belt can be replaced with a smaller belt. If you have a 4 cylinder 2.2 Liter engine or a V6 3.0 to 3.9 Liter engine,...

Hi there. It's 100 degrees here in Phoenix at 11:00 pst, so I understand the extreme heat! What you are describing can be caused by multiple issues, ranging from a coolant system that is clogged with debris to a failing...

An oscilloscope is typically used to look at both the amplitude and frequency of the analog output signal from a two wire Hall Effect sensor, which is the type that you have. Alternatively, you can use a multimeter set to...