Q: My cutlass was running rough before I found out it was leaking coolant from the water pump they fixed that and still leaking have
My cutlass was running rough before I found out it was leaking coolant from the water pump they fixed that and still leaking have To bring it back and there going to replace that but it feels like she holding back heatsting don’t know if my exhaust in the front of the car could be the reason cause I had from the middle to the back replaced in August they said the front was fine now car just sound more rough even when I turn the wheel and it in drive or maybe it’s a fuel pump issue I mean I’m not stalling out or anything but right now I worried about getting stuck and I don’t trust the car right now
My car has 94846 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Check Engine code reads "catalytic converter"
Hello. If you have a check engine code for a catalytic converter then most of the time that is exactly what you need. In some cases a bad oxygen sensor can make it look like there is a bad converter....
Car starts, but dies
If you read your owners manual there is a special procedure to follow after a battery is disconnected or replaced. It's needed to relearn the idle and throttle procedure. If the procedure is not done, then it may take a...
EGR BPT valve & EGR solenoid valve need replacements
Hello there. When codes go away like this, it generally means that the fault has resolved itself or the Check Engine Light has failed in the cluster. If the code is gone this would indicate that there is not a...
Torque converter goes in/out of lock up at cruising speed
Thanks for writing in about your 1999 Chevrolet Suburban. There are DTCs (diagnostic trouble codes) that will indicate faults with TCC solenoid and brake pedal switch circuits. A scan tool can be used to observe brake pedal switch position while...
Mechanic changed cambelt and water pump and whilst returning it, it supposedly jumped off. Engine stopped dead. No more engine
Hello. I hate to say this but it is his fault. It sounds like he is not being truthful about what happened because if that was the case it would have come off well before he worked on it. It...
Do I have to use the exact type of valve stud on my CRV?
Hi there - Honda uses metric nuts/bolts/studs, so any stud with the same metric dimensions will be suitable, regardless of engine manufacturer. Remove one of the remaining good studs for measurement, or simply take one of the good ones in...
Wont go in reverse and drive feels like you are holding brake on 2003 Chevrolet Malibu
Hi - your symptoms describe a very confused transmission. Check first for low transmission fluid (or too much). Check next for problem codes coming from the transmission, whether the Check Engine light is on or not. With this transmission (4T40E)...
When I turn my car slightly to the left, I hear a humming noise almost like a rubbing noise. The steering wheel doesnt vibrate
The noise could be from the wheel bearing rubbing (https://www.yourmechanic.com/services/wheel-bearings-replacement) as it may have dry grease inside the bearing. The noise also could be the power steering pump as there is a load applied to the pump more than steering...
Is there a way to check the ignition timing on my 1999 Chevy Malibu without disassembly?
There is no distributor on your Malibu, instead there are individual coil packs. Ignition timing is adjusted by the power train control module (PCM). You can check timing with a timing light or scan tool, but you will not be...
Related articles
The Best Used Cars to Buy If You're a Carpenter
If If you're a carpenter, and working for someone else, the best used car is whatever you like that gets you to work on time and holds your tools – in short, practically any used car will do. If you...
Oldsmobile Certified Pre-Owned (CPO) Car Program
If If you are in the market for a used Oldsmobile vehicle, it may be that you have considered a Certified Pre-Owned, or CPO, vehicle. CPO programs allow owners of used cars to drive with confidence, knowing that their vehicle...
Understanding the Oldsmobile Oil Life System and Service Indicator Lights
Car symbols, or dashboard lights, are a car service reminder. The Oldsmobile Oil Life System indicates when and what service your car needs.
Browse other content
Maintenance
Estimates