Q: my car sputter when driving had the crankshaft positions sensor done but still doing the same thing had it tested and code was p03

The first problem I think of is spark knocking or pinging. This is when the combustion of the air/fuel mixture in the cylinder does not start off correctly in response to ignition by the spark plug, but one or more...

I did some research and found that the interior dome light is actually controlled by the fuse labeled CTS-PWR-LK. Forums are indicating that this is the number #35 fuse, but you can verify it by checking the fuse panel (https://www.yourmechanic.com/article/how-to-check-fuses-by-rocco-lovetere)....

Hi, thanks for writing in. Unfortunately, I will need a bit more information before confirming if the issue lies in your timing chain or not. Your car can certainly run and start with a timing issue, however it is not...

Hi and thanks for contacting YourMechanic. The inner and outer tie rods on your vehicle can take up to some time. The dealership will change out the tie rod ends and then perform a vehicle alignment, so the time there...

The fuel gauge not reading properly may be likely related to your fuel sending unit (https://www.yourmechanic.com/services/fuel-gauge-sender-replacement) or the gauge in the dash itself. The sending unit is a small float type component inside your fuel tank that measures the level...

Hi there. The first thing a mobile mechanic would do here is complete a car start then dies inspection (https://www.yourmechanic.com/services/car-starts-and-then-dies-inspection) on your Chevrolet Venture. This would allow them to scan your vehicle for any error codes, test drive the vehicle...

Your vehicle requires 5W-20 engine oil. If you suspect that the wrong viscosity is currently in use, YourMechanic (https://www.yourmechanic.com) can [change the oil and filter]https://www.yourmechanic.com/services/change-oil-and-filter). Oil pressure can be verified using an external gauge. If the measured oil pressure does...

It is possible that the fuel pump could have been overheated due to the low fuel level. If the fuel pump overheats it may not work. If the fuel pump does not work the engine will not receive Fuel and...

The torque converter and torque converter lock up solenoid should be evaluated. Another possibility is an internal hydraulic leak in transmission seals causing pressure to apply both reverse and forward gears at the same time, lock up the transmission and...