Skip the auto shop - Our mechanics make house calls

Q: My car cranks but won't start.

asked by on

My car cranks but won't start.. ignition coil, ignition modulator, crank shaft sensor has all been replace.. there is no sparks from the spark plugs. .

My car has 347990 miles.
My car has an automatic transmission.

A: Hello. Wiring from the ECU to the engine sh...

Hello. Wiring from the ECU to the engine should be checked. If no signal is getting to the ignition module, there can be a short in the engine harness or a bad ECU. If you need help having this addressed, a qualified professional from YourMechanic can come to your car’s location to diagnose the starting issue and have this repaired properly.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Sometimes my car starts immediately and sometimes it takes between 5 and 10 tries.

Your mechanic's diagnosis and explanation could well be correct. This is classic symptom behavior of a failing ignition switch. The contacts become "burned" over time and over lots of "start" cycles. The repair is to replace the ignition switch. ...

Q: windsheid wiper only works on fast speed

It is very likely that you are having an issue with your wiper switch as this is the part that controls the speed at which your wipers operate. I would recommend enlisting in the assistance of a quaified professional to...

Q: What will cause a motor to knock?

Hi, thanks for writing in. Engine knock is typically caused by excessive clearance in the lower engine bearings (rod and main). Of course, to know for certain, a professional would need to listen to the noise firsthand. Spark knock, which...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the P0052 code means This code is seen when the Engine Control Module (ECM) tries to control the...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.