Q: My 2011 truck does not start all lights on dashboard turn on like normal but it will not start and it started showing a advancetra

Hey there. Normally a vacuum leak is the most common cause of a high idle but many issues may cause this. Other possible causes of a high idle are improper sensor inputs, an idle air control valve, a faulty engine...

The police cars have higher quality of course. But if you are talking about buying a used one, they generally beat the heck out of them and a lot of them are falling apart. That's why they are trying to...

Hello. It sounds like the weather stripping around the cargo area and the rear doors going bad, which would cause an abnormally loud road/wind noise. I would recommend having the weather stripping replaced in the rear of the truck to...

A few different things can happen when the wrong fuel (https://www.yourmechanic.com/article/how-to-start-a-car-after-filling-with-the-wrong-fuel-by-patrick-haas) is used in a vehicle. This vehicle should not be driven or attempted to start until repairs have been made. The gas will have to be removed from the...

A broken rocker arm would definitely make a lot of noise and cause a constant misfire in the cylinder it is related to. My best advice would be to hire an experienced technician to look over the work to see...

Trouble code P0430 (https://www.yourmechanic.com/article/p0430-obd-ii-trouble-code-catalyst-system-efficiency-below-threshold-bank-2-by-spencer-clayton) is for a catalyst on the drivers side. The sensor after the converter may be bad and not responsive enough or the catalyst itself may be bad. The catalyst (https://www.yourmechanic.com/services/catalytic-converter-replacement) should be replaced if the converter...

Hi there. It's quite possible that the starter has broken, however, it's also common for this type of symptom to be related to a faulty ignition relay, or starter relay. Before you decide to have the starter replaced, you might...

Billing question sent to CS for the cost of labor to replace all four ball joints and the tie rod ends on a 2006 Dodge Ram 1500 with a V8-4.7L engine.

Hi Roger. Although it is possible that your catalytic converter might be wearing out, it's most likely not the source of your oil pressure problem. Typically when an engine develops excessive sludge (caused by carbon deposits from burning gasoline) will...