Q: Moon roof stuck open

Speedometer issues are not very common and sometimes can be caused by things we do. For example replacing the tires. Tires need to be replaced with tires of the exact same size because that is the size that is programmed...

It may have had the ignition switch damaged as well, which would cause the truck to not power up or start. You should check to see if it was damaged during the attempted theft. If it was, it will need...

Hello. It sounds like the steering gear box and/or the power steering pump is going bad. The steering gear box is what is allowing the wheels to turn left and right when using the steering wheel. There are gears and...

You cannot use the engine and transmission combination in your vehicle. Your vehicle is not AWD and the two computer systems are not the same. The two have different wire harnesses as well as different body designs. I recommend not...

Hello. If there are no physical symptoms, it will probably be necessary to rescan the computer and pull the fault codes (https://www.yourmechanic.com/article/how-to-read-and-understand-check-engine-light-codes-by-jason-unrau). A Check Engine Light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) can literally signal any of hundreds of possible problems. The codes will at...

Although P10E(x) codes relates to problems with the Valvetronic gear (cam timing sensors and actuators), I am unable to find a P01ED code specifically. The computer will store information that can be read with a professional-level scanner to help pinpoint...

You may have a cam or crank sensor problem or an electrical issue. You will need to see if the engine has no fuel pressure or spark and test computer to see if there is codes stored to diagnose the...

Hi there: In most cases, the O2 sensors don't impact the transmission's efficiency. However, it can cause acceleration and deceleration issues which can be confused or misdiagnosed as a transmission problem. If the check transmission light came on; you should...

You may have damaged the mounting O-ring seal on the sensor was torn when installing. Remove the sensor and then check the seal O-ring to see if it got damaged and replace as needed. Make sure to lube the seal...