Q: Lock cylinder on 1995 Acura Integra
My key will go in but won't turn completely without wiggling it, I believe I need a new ignition lock cylinder. how much would it cost to have it fixed?
My car has 191580 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Car stopped, steering wheel stuck, check engine light orange
It sounds like you may have a failing alternator (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-alternator). The alternator is responsible for running the electrical system of your vehicle while the engine is running as well as keeping the battery fully charged. If the alternator fails, this...
Engine revs high while idling and then drops about 1000rpms every half second or so.
My guess is that the unstable idle and unintended acceleration is due to a faulty idle air control valve (IAC). The powertrain control module (PCM) uses the idle air control valve to divert air around the throttle. Increasing the amount...
Low idle and stops, sometimes stalls at idle.
As you know, the idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle. As this valve is controlled by the vehicle's computer,...
Following collision damage to a vehicle's front end, which procedures may be used to determine if axle damage exists?
Hello - this task is best handled by a collision repair estimator at a reputable paint and body shop. S/he is trained to evaluate visible and not-so-visible damage, and the costs to repair. Contact a reputable paint and body shop...
Why is there water in my carburetor in my 1998 Jeep Cherokee Sport
The only way water gets into the carburetor is from fuel in the fuel tank. You got the water from the gas station fuel tanks. You need to add drygas (HEET) in the tank to try and get out the...
Why would the push rod come out of my slave cylinder on my 2000 Mitsubishi Eclipse
Hello. If the push rod continues to come out of the slave cylinder then you either have an alignment issue with the cylinder, or more commonly it is because the clutch disc or pressure plate have failed. Too much clearance...
System too lean bank 1
Hi There, Typically, a lean fuel condition will produce DTC code P0171, which indicates a lean fuel condition often times associated with "bank 1 or 2 too lean" as you have indicated. A number of things may cause code P0171...
output shaft speed sensor
Hey, again Brandon. Yes, the output shaft speed sensor is located on the driver side, on the outside of the front differential.
Related articles
A Buyer’s Guide to the 2012 Acura RL
The The 2012 Acura RL is a luxury four-door sedan that offers a decent amount of interior space and seating, as well as appreciable performance (although it’s limited to just a V6 engine). The RL ended production after the 2012...
How to Modify the Alpine Navigation in an Acura or Honda
Modifying Modifying the original equipment manufacturer (OEM) navigation system of your Acura or Honda vehicle with aftermarket software is an easy way to add additional customization features to the already-installed system. Using a simple third-party computer program and a DVD-ROM...
Maintenance Minder and Service Codes For Acura Cars
Acura scheduled maintenance is tracked by the Acura Maintenance Minder system. Main codes A and B combine with sub codes for exact service, like A1.
Browse other content
Maintenance
Cities