Q: Leaking Steering Fluid
The leak is from the Rack at its seal. Can this be sealed better without replacong the rack?
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Engine dead.
Hi, you could of had one of a few different issues that could cause the stall (https://www.yourmechanic.com/services/car-is-stalling-inspection). The first is a recall on the power train control module needing reprogrammed and it is causing stalls during warm up. The other...
my car cranks but doesn't start.
Hi! A bit of info about your car can help us help you. Thanks!
Power steering pump pulley
The shaft size and hole size will only be about .003" difference. The shaft if it measures .748" then the pulley hole will be about .745". This way the pulley will press on and be tight. If you need help...
Limp mode
If you do not use the recommended fluid for Chrysler or any transmissions in general, it can cause the transmission to have shifting and slipping concerns. Even damage can be caused from incorrect fluids being used. This is why I...
Where does ignition usually draw its power? 89 wrangler with 94 chevy 350 and wiring. I'm not getting power to the key. 1989 Jeep Wrangler
Hello - usually power to the ignition switch (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-ignition-switch), engine swap or not, comes through the fuse block. So, first thing to check is the appropriate fuse for the ignition from the Jeep Owners Manual. With the engine swap, unless...
Sometimes, the lower gears are slow to shift (high RPM) when starting to drive from being stopped or almost stop 2012 Ford Escape
Hi there, The "slow shift (https://www.yourmechanic.com/services/not-able-to-change-gears-inspection)" symptoms you are experiencing may be caused by a malfunctioning transmission internal speed sensor, or by a failing throttle position sensor (which communicates with the transmission controller). Either of these could cause the symptoms...
When i turn they key it just clicks could it be the battery or the starter?
Prior to performing diagnostics be sure you have a fully, 100% charged battery that passes a load test (https://www.yourmechanic.com/services/battery-is-dead-inspection). Confirm that the engine immobilizer system (security system) is not activated thus preventing the car from starting. If the immobilizer system...
Replaced power steering pump and fluid is shooting out of cap after driving when i turn engine off
This is probably a consequence of air trapped in the system, and consequent aeration of the fluid, which builds pressure in the reservoir. If you did not experience this problem prior to the pump replacement, it might be due to...
Before work today my car turned on and off in 10 seconds. After work I turned it on and it started leaking green liquid & smoking
The green fluid is probably coolant and the smoke is probably steam. You may have a serious coolant leak that is causing your car to overheat. If the car was driven very far while overheating, it may have caused some...
Related articles
How Often Should Hoses Be Replaced?
Your Your engine needs coolant, the power steering rack needs fluid, and the calipers need fluid to squeeze the rotors to stop the car. Most fluids make their way to their destination through hoses. Those hoses are generally made of...
How to Clean and Maintain Windshield Washers
When When dirt or debris lands on your windshield while driving, your immediate reaction would be to use the wiper fluid spray to clear it. If your car’s wiper fluid doesn't spray properly, it may have clogged wiper fluid nozzles...
The Best Tool to Eliminate Air Bubbles
Air bubbles can form while mechanics perform service on coolant systems. A vacuum coolant filler helps eliminate this problem to avoid serious damage.
Browse other content
Maintenance
Estimates