Q: Is what im doing to the car gonna be positive or a waste of money and time?
Ok my dad gave me a 1995 nissan maxima car sat for 2 years and I decided to fix it up.So far I've replaced the fuel pump,injectors,ignition, 1 ignition coil ,valve cover gaskets, and fuel filter. I'm waiting on my injectors to get here in 2 days. I've also drained all bad fuel and blew the lines. I just want to no since the car has 220025 miles that am I doing all this work and spending all this money for it just to have a major problem down the road or will things work out.I've spent almost around 600 for parts and have done all the work myself. I just need to no if it's gonna be good or bad. Thank u and can't wait to hear ur response good or bad.
My car has 220025 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
When the gas is pressed, the RPM increases, can't accelerate
From what you are describing with the RPMs going high and the vehicle not moving, it sounds like you have a transmission that is not shifting or is slipping. There is a technical bulletin that may stop the flare and...
Limp mode 30 codes
Thanks for writing in about your 2012 Ford E-350 Econoline. Anytime you get a lot of codes for the same thing, it is common practice to document the codes and then clear them. After clearing the codes, road test to...
Car won't pass smog due to computer code P0420 - 2006 Volkswagen Rabbit
This code is related to the catalytic converter (https://www.yourmechanic.com/services/catalytic-converter-replacement). As you may know, the catalytic converter is a section of your exhaust system that helps to complete the combustion process when excess unburnt fuel gases pass through the exhaust. Due...
Truck bogs out under load
First, the EGR tube rusted away will cause excessive air to get into the exhaust and cause the O2 sensors to read erratic. The main reason you most likely have a mass air sensor that is not reading correctly for...
Engine overheating.
Hello. Engine overheating can be caused by a wide variety of issues. I would start by checking the vehicle's coolant level to make sure that it has not run low as this is one of the most common causes of...
Already checked timing Belt, but now it don't recognize the computer immobilizer.
Hi there. Try reprogramming the key fob to your vehicle. Click here to view the procedure on reprogramming your key fob (http://www.carandtruckremotes.com/how-to-program-honda-replacement-car-remotes.html). If the key is programmed to your vehicle, then the immobilizer controller may need to be replaced. I...
Whenever I drive over a small bump on the road, the car gives me a small jump. If I replace the suspension will I get a smoother drive?
If your vehicle is having a popping noise or a bounce effect when driving over bumps, then there could be an issue with the suspension and the shock absorber. If the vehicle is clunking then there could be an issue...
Replaced master/slave cylinder and clutch pedal is hard as a rock and won't depress what could it be?
You need to open the bleeder on the slave cylinder to see if the clutch can be pressed down? If it still cannot be pushed down then the problem is in the clutch master cylinder and it is binding. If...
2016 Audi A3 1.8T loses accelerating power around 40mph, and upon acceleration, it jerks/sputters and slows down instead.
Hi there. With less than 20,000 miles, having acceleration issues on an Audi A3 is definitely not typical. It is likely that you have either an electrical glitch, caused by a fuel or ignition system sensor or electrical connection to...
Related articles
The Best Used Cars to Buy If You're a Farmer
If If you're a farmer, you know that what you need isn’t a used car – it’s a used pickup truck. How else are you going to haul around hay, implements, garden produce, fertilizer, and all the other things you...
The Top 5 Selling Cars in Alabama in 2012
2012 2012 was a great year in Alabama for auto manufacturing, but that wasn’t the only bright spot. Vehicle sales in Alabama were also robust in 2012. Nothing much changed in terms of the vehicle types that were most popular...
Industry News for Automotive Techs: November 5 - November 11
Tesla buys Grohmann Engineering, Ferrari's future hybrids, next-gen Dodge Charger and Challenger, Nissan e-Power system, and YourMechanic recognition.
Browse other content
Maintenance
Services