Q: If my ecm pcm touches the frame and it sparks does it cause the computer to mess up.
I opened my hood and noticed that my ecm had somehow broken off the platick holder it goes on and it was on the body frame of the truck when i lifted it it sent out a spark. And now my truck doesint turn on when i turn the key and theres no messages on the dashboard just the security flashing on and off
My car has 165 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Rear window not going up
The window regulator in that door has broken. The window regulator uses a series of cables and pulleys to move the window up and down. Oftentimes, the pulleys, (which are made of plastic,) will break. When this happens, the cables...
Car runs roughs and overheats
Hi there. This is a problem that comes up often on this car. The most common problem is a leaking intake manifold gasket. This gasket fails and causes a vacuum leak which will make it run rough. Not replacing the...
Pass key fault is on
The keys on these vehicles have a computer chip inside them that is programmed to the vehicle. It is possible that the vehicle may have been attempted to start with a key that is not programmed to the car, therefore...
AC compressor clutch doesn't stay engaged
This would require more testing with the pressure gauges to see if the A/C system cuts out due to low pressure on the low side of the A/C or high pressure on the high side. The most common problem is...
Power loss, won't go up hill.
If your engine is revving but the vehicle is not maintaining speed on hills, then the transmission may be slipping (https://www.yourmechanic.com/services/gears-slipping-when-accelerating-inspection) due to internal clutches. Have the fluid checked (https://www.yourmechanic.com/services/transmission-fluid-service) by an expert to see if it is burned or...
neutral safety switch
In your application, the switch is in the passenger compartment. Of course, prior to replacing it, be sure it is really faulty. There is a test protocol in the Factory Service Manual and you can request that those steps be...
My mini wont start and its not the battery.
Hello, thank you for writing in. You may be facing several issues at once. Start by testing for power at the starter and make sure the power supply is readily available. If there is power to the starter, and it...
2010 VW Routan. current meilage is 56500 the freeway MPG is 24 which is good howver the local mpg now drop from 17 to 11. Why?
Gas mileage can be affected by vehicle condition, tire pressure, or even driving style. If you have been sharing the use of the car in the past year, it could be that your partner has a heavier foot than you...
Engine revs way up when started, then behaves normally. If the car has recently been started, it doesn’t have this issue.
It is normal for the engine rpm to go up to about 1200 to 1400 rpm when first started and then comes down gradually. This is for emissions during cold start and considered normal. If you feel it is not...
Related articles
2012 GMC Acadia vs. 2012 Dodge Journey: Which One Should I Buy?
The GMC Acadia is classed as a midsize SUV, which is able to seat between six and seven passengers comfortably. The 2012 Acadia offers three rows of seating, so passengers will feel the roominess that is typical in a true...
Top Five Selling Cars in Colorado in 2012
Colorado Colorado offers a varied climate depending on where drivers are located. Those in lower elevations see plenty of sunshine all year, while those in the mountain areas can see as much as 300 inches of snow. Due to this,...
How to Get GMC Dealership Certified
GMC car dealerships offer automotive technician jobs to mechanics who are certified through one of the many programs they have available.
Browse other content
Cities
Maintenance