Q: If I put headers on my 2017 F-250 6.2L does it have to be reprogr
If I put headers on my 2017 Ford F-250 6.2L does it have to be reprogram?
My car has 9000 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
How do I repair a seat belt pretensioner?
The seat belt pretensioners are important safety features that help your front seat belts protect you during an accident. The pretensioners can only be used one time, so any time your vehicle is involved in an accident, you should have...
rubbing and pulsating sounds from Left Front Wheel when turning right.
You could have two issues. The first issue that is certain is you have a bad brake rotor or two. Any time you have pulsation when braking, the rotors will need to be machined or replaced. If it is severe,...
Car overheats badly. What's the problem?
Hi, thanks for writing in. This is usually a result of one or several things. Since you have replaced the water pump, we can reasonably assume that is not the problem. Also, since you are replacing the thermostat today, that...
How often are you suppose to replace a new throttle sensor ?
The throttle position sensor (TPS) (https://www.yourmechanic.com/article/how-long-does-a-throttle-position-sensor-last) is only replaced if it tests bad. So there is no fixed replacement interval or "lifetime" for that part. They do occasionally fail though, in which case the Check Engine Light will illuminate with...
blown head gasket?
To answer your last question first, manufacturers of motor vehicles, that would include all of the army of engineers, scientists, and other high trained trained specialists, almost as a rule do not recommend the use of aftermarket "quick fixes", in...
Cylinder 5 has a misfire.
Hi there. To determine if the injector is not working properly, either you can perform a cylinder cut out test on your injection system or you can swap your injector on cylinder number 5 with another cylinder and see if...
Clunking noise hear it at speeds of 35-40 loud
Hi There, What you are describing sounds like a bad or worn out ball joint. A ball joint is designed to pivot through multiple planes. Of course, because the ball joint constantly pivots at different angles, it tends to wear...
We have been told that our crankshaft housing is leaking oil on our 2011 Toyota Sienna. We already replaced the rear main seal.
Firstly, I have never heard of a crankshaft housing. Perhaps they were referring to the engine? The crankshaft is inside the engine and located on the bottom side of it. The pistons are all connected to the crankshaft and the...
Where the orifice tube on 2013 Chrysler 200
Hello, thank you for writing in. The orifice tube is located in one of several places. For your make and model, you should be able to locate it between the condenser outlet and the evaporator inlet. It will be placed...
Related articles
The Best Used Cars to Buy If You’re an Athletic Coach
If If you are an athletic coach, you need a used vehicle with tons of room to transport gear. Once in awhile, you may have to take a player or two along with you as well. What this means is...
The Best Used Cars to Buy If You're a Skier
When When summer ends, skiers start thinking about hitting the hills, and that means having to contend with winter driving conditions. Not just any vehicle is going to get the job done. We have evaluated several used ski-worthy vehicles, and...
The Best Used Cars to Buy If You're a General Contractor
If If you're a general contractor, you probably aren’t in the market for a used car. More likely, you’re looking for a pickup truck, because you need to haul equipment and supplies to various job sites. Most contractors will likely...
Browse other content
Cities
Maintenance
Services