Q: Iam looking for an EGR vavle or system on my 2013 2.0 L4 engine and cant seem to find any good info on this.I was tolded that is w

It’s imperative that your vehicle is equipped with the coolant, especially if you use the air conditioning. The ideal coolant mixture for your car is 50% water, and 50% ethylene glycol antifreeze.

If the driver-side door is open while the engine is running and the door lock button is pressed, then all doors will lock and then the drivers door will unlock. The same will occur if the door lock button on...

A crank, but no start condition can be caused by many things. Depending on how strong or weak the vehicle is cranking, the no-start condition can be caused by a low battery, a problem with the fuel system, or even...

The bearings inside of the water pump (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-water-pump) are sealed from the outside air by a rubber seal. They are also sealed from the inside water by a rubber seal. If they weren't, the water would get on the bearing...

Hello, when you removed the pump you may have relocated clutch plates in the input housing. These plates must align with a hub assembly. What happens is that the pump puts pressure on the housing because there is no...

Hi - most likely the reverse light switch (https://www.yourmechanic.com/article/how-long-does-a-backup-light-switch-last) is working erratically. It is mounted on the gearbox, and is subject to vibration as well as oil on the switch contacts. I recommend a reverse light switch replacement (https://www.yourmechanic.com/services/backup-light-switch-replacement) by...

Hi there. More likely than not, the problem you are describing is not caused by a dead battery; but instead, bad battery cables. However, it is possible for a battery to drain to the point where attempting to jump start...

Hi there. Check the alternator and see if its not charging properly. Charge up the battery and start the engine. Check for a voltage on the battery with the engine running and see if its between 13.5 and 14.7 volts....

The Idle Air Control valve got damaged when the throttle body was cleaned. I suggest removing the IAC valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) and cleaning it out. The electronics could be wet causing the valve to change the engine idle and the computer...