Q: I replaced the brake light switch and thel lights are still on

Safety belt pretensioners play a large role in keeping you safe in your vehicle. The pretensioners are part of the front seatbelt system, and are responsible for tightening the tension in the seatbelt when an accident occurs. The pretensioners only...

Hello. This vehicle should not shake like this when driving at high speeds. If it only occurs at higher rates of speed then it either has a warped front hub assembly or it may have a problem with the alignment....

Hi, thanks for writing in. I would proceed to carefully continue with the hammer and chisel. You could also try using a punch with the hammer to try and spin it out. The sudden shock from the punch could help...

What problem codes are set? Most often, these symptoms are the result of a failed throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement). Traditionally, cars will have a throttle cable but your Saturn has a "fly by wire" throttle system. If the engine management...

Hello. Stalling can be caused by many things. If the engine is no longer overheating, then it is unlikely that the stalling is directly related to the radiator repair. A few common causes for stalling when braking are a faulty...

Hello. If you switched the spark plugs relating to two different cylinders and the same cylinder exhibited the same signs, then the issue is related to the other components on that cylinder. The test you performed was a great one....

Hello, thank you for writing in. The VSA or Vehicle Stability Assist system is designed to work with the ABS system to keep control of the vehicle at all times in all conditions. It uses several of the same sensors...

Hello, As you may know, there are a number of things that can cause a misfire ranging from faulty ignition parts to changes in air/fuel mixture, fuel pressure, timing an the list goes on. If you do know you have...

You can mix synthetic and conventional (mineral) oil in any ratio that you desire. If you were told by anyone not to do that, simply ask him or her for the documentation, as published in a reputable automotive technology journal...