Q: I replaced the a/c condenser on a 2008 pacifica, ever since the transmission is acting like its slipping. Help

The ashtray is located directly in front of the shift lever. To access it, pull the lid out to open. The ashtray can then be pulled straight out until it is removed from the vehicle, at which point it can...

Hi there. There is indeed a recall for this exact issue - it is #06186 (http://www.suzuki-forums.com/2g-1999-2005-vitara-grand-vitara/22567-front-crossmember-corrosion-rust-through-recall.html) and it calls for crossmember replacement. I recommend you present this recall (https://www.yourmechanic.com/article/what-to-do-if-your-car-is-recalled-by-jason-unrau) to the dealer so they can make things right.

Hello. It sounds like something is mechanically binding and/or you are not getting full power assist. If it is mechanically binding, one cause would be defective strut bearing plates (top of strut in wheel well). You can evaluate that by...

This is a common issue with the ABS systems in many cars when the wheel speed sensors (https://www.yourmechanic.com/services/wheel-speed-sensor-replacement) are going bad. All of the wheels on the car have wheel sensors that monitor the speed of the wheels and relay...

Hi, thanks for writing in. In my 35 plus years of servicing vehicles, I have never seen a strut go bad when I lifted a vehicle on a lift, however this does not mean it is not possible. When the...

Hi There, Generally, the check engine light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) comes on when something fairly serious is going on with the vehicle. This can happen for many different reasons such as a faulty mass air flow sensor, a faulty O2 sensor, a...

I would have the knocking sound investigated and resolved first because it may be engine related and thus a priority. The relevant service to request is an engine noise diagnostic (https://www.yourmechanic.com/services/noise-from-engine-or-exhaust-inspection). Vibration felt in the steering wheel is usually tire...

If you have the controls set to heat, and there is airflow but the airflow is cool, that typically means that the heater control valve (https://www.yourmechanic.com/services/heater-control-valve-replacement) is stuck or otherwise non-functional. To have that component inspected, and replaced or serviced...

Hi Raymond. Thanks for contacting us today. If a sensor that makes up the ABS or traction control system is unplugged or removed, it's common for the mechanic to download any stored OBD-II trouble codes after restarting the vehicle, removing...