Q: I replaced my compressor clutch on my 2005 Duramax and it started working working again I added some more refrigerant and it is at

While lowering a car or truck can make it look cooler, increase aerodynamics, and provide a lower center of gravity, more often than not there are downfalls to consider (https://www.yourmechanic.com/article/what-are-the-dangers-of-lowering-my-car) as well. This process can be done professionally but is...

This engine had quite a few different issues that may of caused a no start. The list is ignition module, distributor stator, fuel pump, fuel pump relay, timing belt, ignition coil and wiring issues. The only way to fide the...

It sounds as though your door latch has failed. If this happens, your door will not be able to stay closed. I would ask for assistance from a mechanic at YourMechanic, so they can come to you and repair your...

The fuel lines should not get clogged, unless they got damaged in some way or the lines pinched when repairs were made, for example, if the fuel tank was removed and replaced. The fuel filter, fuel injectors, pressure regulator may...

There is no easy way to correct a jumped timing belt. You will need to disassemble a portion of the engine to gain access to the belt tensioner, so you can move the belt back into position. I suggest replacing...

Hello. This may be related to either a bad ground connection from the battery (https://www.yourmechanic.com/article/how-to-check-a-car-battery) or potentially a bad voltage regulator (https://www.yourmechanic.com/services/instrument-voltage-regulator-replacement). The other end of the black battery ground cable should be connected to the chassis of the car...

Hi - yes, almost certainly this is the water pump bearing seal leaking (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-water-pump). I would replace the water pump immediately. Modern water pumps have a remarkable ability to hold water right up to the instant they fail completely -...

The catalyst should be replaced as soon as possible if it is bad. The backpressure on the engine will cause the engine to run with less power and may overheat the engine valves resulting in engine damage. the catalyst can...

There are a number of things that may cause the car to hesitate (https://www.yourmechanic.com/services/engine-hesitates-during-acceleration-inspection) when accelerating such as low fuel pressure, a dirty or faulty mass air flow sensor, clogged or dirty fuel injectors, a faulty throttle position sensor or...