Q: i put gas treatment fluid in my brake fluid what can i do

asked by on February 24, 2017

I put gas treatment fluid in my brake fluid while trying to refill the brake fluid
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

When Should I Replace My Oil Filter?
Consistently changing a vehicle’s oil filter is as important as changing its oil (https://www.yourmechanic.com/services/change-oil-and-filter). While some drivers, such as those who do deliveries or other frequent driving, may require oil filter changes more often. The general rule of thumb for...
Heard a thunk and lost throttle
There are several possible things that could have happened. If the car is running, but has no throttle response, the throttle body could be bad. This is the part that opens as the accelerator is pressed to let more air and...
Loud engine noise
If you are hearing a rattling noise on start up and for a couple of minutes that then goes away, then the variable valve timing actuators are at fault. The manufacturer is working on a replacement now, and will issue...
Spraying the bottom of the car during car wash
You are just spraying the bottom. The bottom itself doesn't have any delicate stuff under there. Everything under there is sealed so you go ahead and spray under there, especially the area where you get a lot of salt in...
Crank no start
The fact that it requires ether to start suggests that you may have a fuel delivery issue. Since you mentioned it now has a new fuel pump and filter, try tracing the fuel delivery up through the fuel rails. Sometimes,...
My headlights are not working correctly - 1996 Chevrolet Blazer
Hi there. Most of the time this is caused by a bad headlamp switch. When the switch fails, it will cause this to occur. If the switch is fine, then it may have an issue with the headlamp relay. I...
Cylinder 2 Misfire, and water contamination in the fuel.
Hello. If your fuel was recently contaminated with water then that is likely the reason behind the cylinder 2 misfire. As the fuel travels to all of the cylinders, this leaves them all susceptible to misfires, as well as the...
There is a loud humming noise coming from under the car becomes louder when I let off the gas
A common cause of the type of noise you are describing is one or more failed wheel bearings. The exact wheel position can be determined using chassis ears (remote wireless microphones). Not to worry, as replacing wheel bearings on most...
I have a. 2000 Mercedes Benz S500. It suddenly won't go into reverse. What should i do? 2000 Mercedes S500
Hello - your Mercedes transmission is in "limp mode (https://www.yourmechanic.com/question/car-stuck-in-limp-mode)". Something has failed in the transmission, and it has engaged 2nd gear as a limited means of getting you to a repair shop. If you could forward the specific codes...

Related articles

A Buyer's Guide to the 2012 Chevrolet Caprice PPV
With With the phasing out of the long-lived and beloved police cruiser in the form of the Ford Crown Victoria, 2012 brought a new car into town via the Caprice PPV (Police Patrol Vehicle). This new incarnation of an old...
A Buyer’s Guide to the 2012 Chevrolet Tahoe Hybrid
Chevrolet Chevrolet has always had a good name when it comes to the vehicles they make, and that is doubly true for their SUVs. The 2012 Chevrolet Tahoe Hybrid has all of the great features that you would want from...
The Top 5 Selling Cars in Alaska in 2012
Alaska Alaska requires a different kind of vehicle to handle both the terrain and the wintery conditions. While some of the most popular options for the Alaskan terrain in previous years included options such as the Subaru Forester and the...