Q: I noticed recently that the water is attenuated from the reserve water tank connected to the radiator and crystals are on it...

The ignition key lock cylinder on the 2001 to 2007 Ford Focus is prone to binding and sometimes will not release, causing the key to get stuck. The fix is to replace the ignition key lock cylinder in the steering...

Losing control of your vehicle can be frightening to say the least. If your vehicle begins to skid, there are three types of skidding it could be: The “braking skid” in which the wheels will not be rolling The “steering”...

The easy way to do it is to replace the hub assembly (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-wheel-hub-assembly) if you have a lot of miles on them since it will give you new studs and bearings. If you want to just replace the studs, you...

Yes, the catalytic converters would often rattle. Catalytic converters look like mufflers but they are not. They have platinum inside these ceramic pieces and the hot air goes through them and burns hydrocarbon. What happens is, the ceramic parts start...

This may be potentially a faulty starter relay or starter relay fuse. I would start by checking the fuse in the fuse box for the starter relay (should be a 40 amp fuse). I would also recommend checking the alternator...

Hi there. As you may know, this is most likely related to the power steering in your system, which is electric unlike earlier generations of cars that were hydraulic. This is also a known issue with the 2010 Chevy Malibu...

Hello. The symptoms you are experiencing can be caused by a wide variety of issues. If the symptoms appear to come and go then it may be possible that the symptoms are electrical in nature. A few things I would...

Hi there. Check the battery cables (https://www.yourmechanic.com/services/service-battery-cables) to see if they are are tight and clean. If the cables are loose or corroded, then clean them and tighten them up. If the cables are fine, then check the battery voltage...

Hi There, The majority of brake pads (https://www.yourmechanic.com/services/brake-pads-replacement) on most cars start out with about 12 mm of material on them. You should definitely replace them by the time they get down to 3-4 mm of material and certainly at...