Q: I need to know what the wire is called that goes from the alternator to the starter 95 deville

Hello, thanks for writing in about your 2002 Mitsubishi Lancer. If you are trying to remove the grill, it is attached to the front bumper. You cannot remove the tabs without breaking them. You have to remove the entire bumper...

Hello. This is most likely a faulty fuel sending unit (https://www.yourmechanic.com/services/fuel-gauge-sender-replacement). This is a unit that sits in the fuel tank that sends a signal relaying how much fuel is in the tank. These commonly go bad on many cars....

The usual cause for a battery light to come on is a fault in the charging system. If the alternator is not charging and providing electrical power, then the electrical system will resort to draining the battery for power. Since...

Hello - there are several possible sources of the gearlube leak in the rear end housing: the pinion shaft seal, the large diameter area where the differential carrier is bolted to the rear axle housing, or the rear axle vent...

it sounds like your starter solenoid may be failing. The starter solenoid is located on the starter and has internal electrical contacts that transmit electricity to the starter. When this fails, it may cause a clicking sound and will not...

Hi There, This is usually a case of a bad U-joint that has excess play in it. As the transfer of torque moves from the transmission through the drive line to the rear end, this puts a tremendous amount of...

The inner tie rod nut should be torqued to 90 to 100 foot pounds and secured with lock.