Q: I need to know how to reconnect a bose above the trunk speaker in a nissan maxima

I would have the fuel system checked out by YourMechanic. They will need to put a pressure gauge on the fuel rail to test for fuel pressure. It sounds like you may have a bad fuel pump, in which case,...

First thing you'd want to do is change the shocks (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-air-shocks) and struts (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-strut-assembly) on it. When they are worn, and the wind blows, it's going to go to go all over the place. It's going to start moving too...

When you start your car or turn on the key do you have a yellow light that says ABS in it? If you do then you have ABS and you should order the hub with ABS. If an ABS light...

Your car is equipped with brake pad sensors to detect when the brake pads are getting low. The indicator on the dash is simply notifying you that the sensor has been tripped, and it's most likely due to worn brake...

Hi, thanks for writing in. I recommend testing the fuel pressure and monitoring the pressure after the key is turned off to see if the pressure drops to zero. If it does, then the system will need to be tested...

After some testing done to verify the EGR valve flow to see if the valve is intermittently sticking open causing the stall. This can be done using a scanner with the capability to open and close the EGR valve and...

Hi Paula...what you are describing is not unusual and is readily repaired excepting under one circumstance and that is if the collision caused any damage to the sub-frame and/or the mounting bosses that hold the control arms. All other parts...

The code P0193 pinpoint test should be done to verify the pressures and sensor indicate the same. You most likely have a defective sensor for the fuel pressure on the fuel rail. Replace the sensor and clear the codes. If...

Hi Alex. When a timing belt breaks, it can cause internal engine damage beyond what's inside the timing belt cover. However, in most cases, when you can't start the car afterwards, it's due to the ignition timing not being properly...