Q: i need to find the fuel cut off switch on a 2003 mazda portege mazdaspeed

There are three ways to change the radio station. Rotate the TUNE/SCROLL button. Rotating the button to the right will take you to a higher radio number, while rotating the knob to the left will lower the frequency. Press the...

Hello you should have a mechanic inspect the 'no start' issue (https://www.yourmechanic.com/services/car-is-not-starting-inspection). The power to the starter needs to be checked. There are two wires going to the starter, a big wire which should have battery voltage at all times...

Changing out parts for the no start may lead to replacing the correct part, but it may take a few parts and money. I suggest having a qualified mechanic come and diagnose the no start (https://www.yourmechanic.com/services/car-is-not-starting-inspection) by checking fuel pressures...

Hi there. There are a few tricks you could try like using compressed air (https://www.yourmechanic.com/article/how-to-use-a-hair-dryer-to-remove-a-dent) to get the dent out (if it's not too big). There are also some products out there that claim to be able to remove dents....

Hello - the symptoms you provide regarding the lack of Reverse suggest either the Reverse clutches are burned out, or the Reverse piston servo seals are leaking so the Reverse clutches don't actuate. With the "shaking in Drive" you mention...

Hello, thanks for writing in. I believe you are saying that there is a problem with the car cranking; both before and after replacing the battery. And, that applying a booster power source did not improve the ability of the...

This may be a sign of a faulty MAP sensor. The Manifold Absolute Pressure (MAP) sensor senses engine load and generates a signal that is proportional to the amount of vacuum in the intake manifold. The engine computer then uses...

This light will usually come on when one of two things are happening. Either the motor is in fact low on oil or the oil pressure sending unit (https://www.yourmechanic.com/services/oil-pressure-sensor-replacement) is not working properly and may be producing a faulty reading....

Hi there. The code you've indicated is a Kia-specific trouble code that indicates four possible problems including, the Intake Manifold Runner Binding Or Sticking, a Faulty manifold flow valve, the manifold flow valve harness is open or shorted or the...