Q: I just replaced the fuel pump on my car and charged battery, it inconsistently rolls over but it will not crank

Your car’s air bags are designed to keep you and your passengers safer during certain types of impacts. However, they can pose dangers on their own. air bags inflate very quickly, and if you’re sitting too close to the steering...

Hello, I would enlist the help of a mechanic to inspect the engine (https://www.yourmechanic.com/services/engine-hesitates-during-acceleration-inspection) because this problem could be a number of things. I would do a tune up on it's spark plugs, air filter, fuel filter and then go...

I am from the deep south and do not see any snow, but have been in areas of heavy snow in my career. My first thought would be that the vehicle rear springs were subjected to being compressed for a...

Those faults are two totally separate issues. The P0441 is an evaporative emissions system fault, and the P0089 is a fuel pressure regulation fault. This generation of Audi A4 was notorious for high pressure fuel pump problems. There were multiple...

They have both. You can get a 2006 Ford Fusion equipped with a 4 or 6 cylinder engine (https://www.yourmechanic.com/article/what-do-different-cylinder-numbers-mean-in-regards-to-engine-performance-or-reliability).

In order to replace the rear bulb that is not working you have to remove the light assembly. The blinker on the dash blinks fast when there is a light bulb on that side is burned out in most cases....

This indicates there is a problem in the Anti-Lock Braking System (ABS). In this system, the VSA modulator control unit monitors wheel speed via sensors. If from the sensor signals the module determines wheel lockup is about to take place,...

Hello there, thanks for writing in. I'd be happy to offer my insight on this. The correct time to replace the rotors on a vehicle will depend on many factors including driving conditions and mileage. If there is no noticeable...

Trouble code P0843 (https://www.yourmechanic.com/article/p0843-obd-ii-trouble-code-transmission-fluid-pressure-sensor-a-circuit-high-by-logan-utsman) pops up quite frequently on vehicles such as your Honda CR-V. The 2nd clutch transmission pressure switch is installed in the hydraulic pressure circuit to the 2nd clutch. The Powertrain Control Module (PCM) uses this information...