Q: My car makes noise in reverse and when making complete turns.
I just replaced my upper ball joints, tie rod ends, and hub assembly, how ever my car grinds when in reverse also when I make complete turns. What could be my issue?
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Lost power driving in traffic
This model year F-150 engine has had a few concerns that relate to the problem you are having. The first step in diagnosis is to verify if problem only happens during wet, damp or humid conditions. YourMechanic will then need...
Is My Rear Wiper Legally Required to Operate?
Federal Motor Vehicle Safety Standards (FMVSS) specify that manufacturers must include rear wipers on all new motor vehicles sold in the United States. However, current FMVSS standards do not require that a passenger motor vehicle be equipped with a rear...
Active Body Control problem
Hi. It sounds like there was a small leak in the system that has turned into a bigger one, and now the system can't hold any pressure at all. Typically, there will be puddles of hydraulic fluid leaking from the...
Air conditioner condensation does not drain
Hello. We will be happy to assist. Most likely you have an AC drain port that is clogged. It's best to blow out the drain port with compressed air to ensure there is a clear drain passage. If there is...
My car has low oil pressure. I've already changed the oil pressure sensor 3 times.
If you have replaced the sensor three times and it did not fix the problem, then you may have problems with the oil pressure being low at idle due to wear in the engine bearings. The reason it would be...
Low kilometers on the odometer
Hello. The best way to determine if the odometer on a vehicle has been rolled back is to compare the readings with the maintenance and service records. At 20000 kilometers there should be at least a few service records to...
The check engine, Trac off and Vsc light came on my car. The code that came up is P0446 (Evap System Vent Control Fault).
Hi there. That light is not going away until the fault has been properly diagnosed. The code may or may not be the same. The code that is stored is a guide for a qualified technician to use. It does...
Car starts but won't drive and all the lights on the dash board are on.
Hi there. The battery is beyond charge and needs replaced. After replacing the battery, you would need to check for a parasitic load on the vehicle to see why the battery lost power. Disconnect the negative battery cable and put...
I have a 1996 chevy k1500 and I just put a new motor in it and it will start and run and idle amazing but has no power in drive
Check to see if ignition timing is advancing per the specifications in the factory service manual as you rev the engine. Measure fuel pump pressure. Check throttle position sensor, oxygen sensors, vacuum leaks, ignition system malfunctions, bad valve timing if...
Related articles
Symptoms of a Bad or Failing Fuel Pump
Common signs include a whining noise, hard starting, engine performance issues, and an inability to start the car.
How to Get Lincoln Dealership Certified
Lincoln dealerships offer automotive technician jobs to those who are Lincoln certified through UTI’s Ford Accelerated Credential Training program.
How to Troubleshoot a Car Exhaust or Engine Noise
Car exhaust systems and car engines make whirring, clicking, or sputtering noises if there's a faulty belt, alternator, water pump, or tension pulley.
Browse other content
Services
Estimates