Q: I just replaced my lower control arm on the passenger aide of my 2002 ford escape and now after doing that my steering wants to je

The fuel pump sending unit is most likely the cause. The system needs a steady signal from the sending unit in the fuel tank to keep the needle from jumping around. I recommend seeking out a professional mechanic, such as...

A common failure in your engine is the intake manifold and intake plenum gaskets. When this happens coolant will leak under where the throttle body is located. I would recommend having a certified mechanic, such as one from YourMechanic, inspect...

It could be the spark plug (https://www.yourmechanic.com/article/symptoms-of-bad-or-failing-spark-plugs), ignition coil (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-ignition-coil), or coil boot causing the misfire. You may also have dirty fuel injectors (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuel-injector) that need to be cleaned. Have the ECM scanned to see if the misfire code is...

Hello. When vehicles have higher mileage, it will burn oil faster and will lose a half-quart to a full-quart every 1,500-2,000 miles after the oil has been changed. This is normal for vehicles with higher mileage and does not require...

Often times, premature tire wear can be attributed to how a vehicle's suspension is aligned (https://www.yourmechanic.com/article/why-is-it-important-to-have-a-vehicle-s-suspension-aligned). On the CLK320, the manufacturer settings indicate a slight positive toe setting (tires are toed inward) and a negative camber setting (top of the...

Hello. If your vehicle is leaking antifreeze, especially at the water pump, then I would stop driving the vehicle and get it repaired as soon as possible. An engine leaking at the water pump is likely to overheat quickly, which...

As with most modern cars, things are more complicated than they seem. The BMW uses a lamp control module to power up the lights. It's not a simple switch-load connection anymore. Among other functions, the lamp control module senses malfunctions...

Hey there. This may be a sign of a dirty or failing idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) or potentially an intake air leak. The idle air control valve monitors the air intake as it is mixed with fuel as it...

Hi there. The bolt that cracked the manifold will not cause the cylinder 1 to misfire. The misfire is caused by a faulty spark plug, a faulty spark plug wire, a faulty fuel injector, or a burned valve. Check the...